Aluminum Front Lower Control Arm – Right

This is the front control arm with the upward facing ball-joint, commonly referred to as the “wishbone”.

Over the years, the road takes a serious toll on your suspension. Pot holes, speed bumps, and road hazards all contribute to a sloppy, weak suspension. To give a better feel to your driving experience, change components as they wear to improve safety and ride comfort.

One item to replace is the control arm. After years of service, the non-serviceable ball joints and other components can begin to wear out. Because some components cannot be replaced, the only solution is replacement of the entire arm.

Euromotiv has your replacement with this TRW made piece, a quality aftermarket unit that will restore your suspension. A tighter feel, less shake in the steering wheel, and more solid performance when hitting road hazards such as pot holes and bumps. Not only will you feel safe in your vehicle again, you can also feel comfortable.

If replacing any part of your front or rear suspension, it is best to either do it in pairs (both left and right sides), or examine parts that are prone to failure. This will provide the most service life out of replacement parts and assure they are all performing properly. Skim through the suspension section of your vehicle model to see all those other parts that may need replaced.

A common cause of noise in the front suspension, usually due to a failed ball joint.