Description
The ARM MK7 Bi-Cooler Piping Upgrade allows you to run the ARM MK7 FMIC (ES4375686) with the OEM intercooler, or any upgraded OEM location intercooler that fits the OEM charge piping. The ARM MK7 Bi-Cooler Upgrade is the ultimate solution to boost the performance of your MK7's charge-air cooling system. The ARM MK7 Bi-Cooler Upgrade features a unique dual-cooling setup that significantly improves the heat dissipation of your Gen 3 EA888, allowing for lower IAT's, higher power output and increased cooling efficiency.
Made from 6-Layer Steel Wire Reinforced Silicone, the ARM MK7 Bi-Cooler Piping Upgrade can handle over 50psi, and anything you can throw at it. To secure the boost, the ARM Bi-Cooler Kit uses constant-tension T-Bolt clamps to prevent any loosening over time.
The ARM MK7 Bi-Cooler Piping Upgrade maintains a consistent 2.5" diameter throughout the entire system to maximize volume while maintaining charge-air velocity. In testing we found the ARM Bi-Cooler Setup to be incredibly effective, pairing the ARM MK7 FMIC with just the OEM intercooler we were able to see IAT's around only 13 degrees above ambient.
Included:
- ARM MK7 Bi-Cooler Piping - Driver Side
- ARM MK7 Bi-Cooler Piping - Passenger Side
- ARM T-Bolt Clamps
* The ARM MK7 Bi-Cooler Piping Upgrade is designed to work specifically with the ARM MK7 FMIC (ES4375686). Therefore the ARM MK7 FMIC (ES4375686) is a requirement for fitting the ARM MK7 Bi-Cooler Upgrade successfully.