Description
One of the most frequent complaints after installing lowering springs is poor ride quality. As with any of Emmanuele lowering spring options, the goal with is to keep ride quality as close to stock as possible, while adding a subtle but very proper drop. The linear design of these springs have a consistent rate as the spring sees higher load. On light bumps, it will allow the chassis to follow the road well (minimizing the bouncy feeling), while under heavy compression it will stiffen to prevent bottoming out. In our experience, this creates a much better overall ride quality.
Each spring set is 100% made in the USA exclusively for Emmanuele Design. The springs are made of high tensile chrome silicon and each unit is shot peened, pre-set and 100% tested to insure all the critical dimensions and rate/loads are within tolerance. The springs are then powder coated with a stealth black finish for an OEM appearance. The use of high tensile chrome silicon, as opposed to typical commercial grade chrome silicon, allows us to create a lighter spring that can sustain repeated deflection without deformation. High tensile chrome silicone will typically have thinner coil diameters that are spaced further apart, when compared to commercial chrome silicon.
*On standard suspensions they lower the car approximately 1.6" Front & Rear, on sport suspension the drop is approximately 0.8" Front & Rear.
- EMD-B9Q-LS