NEUSPEED Power Module

NEUSPEED Power Modules ship to your door and install on your own time. No need to rent complicated devices or drive your vehicle long distances to tune your vehicle. This device can be installed by any individual within an hour with the supplied, easy-to-read instructions and net you up to 40+ HP on 100 Octane fuel.

Features:

Two position switch:

• 91+ Premium Fuel / 5 PSI Increase
• 100+ Octane Fuel / 7 PSI Increase

Power / Torque Gain:

• 1.8 TSI: 30+ HP / 55+ ft./lbs.Torque
• 2.0 TSI: 35+ HP / 70+ ft/lbs.Torque
• 2.0 TSI "Budack/Miller Cycle": 30+ HP / 55+ ft./lbs.Torque

Increases boost by modifying the charge pressure and map sensor readings

• Allows ECU to remain in control of boost
• The actual boost is increased by a precise amount
• Boost is increased in a gradual, progressive fashion
• Uses the closed loop control of the ECU to increase boost

Readings in the vacuum region are stock

• No effect on cold start
• No effect on warm-up
• No change to idle, cruise and moderate acceleration modes of operation

Retains stock ECU programming

• No change to factory ECU programming, communication or safety protocols
• No ECU TD1 code to void manufactures warranty
• Not effected by ECU reprogramming by the dealer
• Makes use of existing ECU programming for higher boost levels
• Correct Air/Fuel mixture maintained from the wide band O2 and closed loop mode of the ECU
• Ignition timing optimized by the ECU

Easy Installation

• Plug-and-play intercept at Boost and MAP sensor connector locations
• Installation or removal can be completed in a few minutes
• No trace Power Module was ever there after removal
• Power Module can be sold or installed on another vehicle of the same engine type.

*Pending CARB Compliance

****NOTE: DO NOT USE POWER MODULE IF ECU HAS BEEN TUNED OR MODIFIED****

Not for sale or use in the state of California on any pollution-controlled vehicle as per the California Air Resources Board.